Apr 292010

Hi,

reasonable results of my Plato and Pitatus captures from April 23rd are still pending. I tried Registax 5.1 with the Plato AVI yesterday without success. A first run with a single alignment point to check out the AVI’s potential lead to a good but not spectacular result near the alignment point, a sharp crater rim and craterlets close to the AP well defined. Multipoint processing was not that good. The automatic MAP selection resulted in a horrible image with alignment areas washed out and harsh seams between the areas, carefully choosing 12 points manually wasn’t much better :(
Ok, I switched back to AVIStack. The first AS processing I tried was fine outside the crater where the harsh terrain has good contrast for the AP tracking. Only the crater floor was completely washed out. I parametrized AS as suggested by Michael Theusner himself and others with increased correlation area radius and higher smoothing factor settings. The estimated¬† processing time of 8 hours compared to a fraction of that before required running the job overnight. Unfortunately Windows 7 decided to reboot after updates during the night although it shouldn’t, needless to say all processings are lost :( Jeez, who’s programming this stuff…
I’ll retry today, if AS still has issues on the contrastless crater floor I might switch back to manual MAP processing with several single point runs and insert the crater floor into the otherwise fine AS result. It looks like these captures with high frequency seeing oscillations and prominent noise are a very hard nut to crack. A bit surprising to me since I always have been amazed how good AS is tracking alignment points on almost no contrast in the footage.

Cheers, Oliver

Mar 182010

Hi,
the Captifier development went pretty well the last days, a nice setup dialog is done, functionality growing towards a first usable version and…
… my develpment machine died today :( The graphics section of the laptop is dead, looks like a total write-off. I’m currently backing up all data, development is stalled until I have a replacement machine up and running. Needless to say how I hate that so please excuse my french… Life is what happens to you while you’re busy making other plans… ;)

Cheers, Oliver